Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Powertrain / Heat Insulation / Heatshields - Vehicle Mounted / DA-RM-05E001-02-001 - Remove/Install heatshield - Bulkhead
Preparation work
1.     
2.     
3.     
Care Point: Depressurise suspension system before disconnecting battery.
4.     
Care Point: Remove both sides.
5.     
Care Point: Make sure EPB calipers are in service mode before disconnecting battery.
6.     
7.     
8.     
9.     
10.    
Care Point: Remove both sides.
11.    
Care Point: Remove both sides.
12.    
13.    
14.    
Care Point: Remove both sides.
15.    
16.    
17.    
18.    
19.    
20.    
21.    
22.    
23.    
24.    
25.    
26.    
Care Point: Remove both sides.
27.    
Care Point: Remove both sides.
28.    
Care Point: Remove both sides.
29.    
Care Point: Remove both sides.
30.    
Care Point: Remove both sides.
31.    
32.    
33.    
34.    
Care Point: Remove both sides.
35.    
Care Point: Remove both sides.
36.    
Care Point: Remove both sides.
37.    
Care Point: Remove both sides.
38.    
Care Point: Remove both sides.
39.    
Care Point: Remove both sides.
40.    
41.    
Care Point: Remove both sides.
42.    
Care Point: Remove both sides.
43.    
Care Point: Remove both sides.
44.    
Care Point: Remove both sides.
45.    
46.    
47.    
Care Point: Remove both sides. Detach caliper from upright only, do not disconnect fluid hose.
48.    
Care Point: Remove both sides.
49.    
Care Point: Remove both sides.
50.    
Care Point: Remove both sides.
51.    
Care Point: Remove both sides.
52.    
53.    
54.    

Remove heatshield - Bulkhead
1.  
Remove clips (1).
 
2.  
Remove the trim (2).
 

3.  
Remove clips (3).
 
4.  
Remove the heatshield - Bulkhead (4).
 


Install heatshield - Bulkhead
 
Care Point:
Inspect bulkhead heatshield gasket for signs of damage, replace if necessary.

 
1.  
Install components in reverse order.
 

   
   
   Note