SERVICE INFORMATION SYSTEM
Repair instructions
Body Structures
Body Panels and Closures
Panels
Body Panels Service Procedures
Rear Panels
Front Panels
Bodyside Assembled
DA-RM-02A051-03-001 - Remove/Install bodyside - Upper - Left
DA-RM-02A051-03-002 - Remove/Install bodyside - Lower
DA-RM-02A051-03-003 - Remove/Install panel - Dirty air duct
DA-RM-02A051-03-004 - Remove/Install panel - Side duct finisher
DA-RM-02A051-03-005 - Remove/Install panel - Aero bridge
DA-RM-02A051-03-006 - Remove/Install heatshield - Airbrake
DA-RM-02A051-03-007 - Remove/Install bodyside - Upper - Right
DA-RM-02A051-03-008 - Remove/Install Panel - Hinge cover - Upper
Engine Bay Panels
Closures
Active Aero
Glazing - Closures and Dynamic
Body Exterior
Chassis
Powertrain
Electrical
Interior
Accessories
PDI/Service/Track/Technical Sheets
Paint Technical Data Sheets
Wiring Schematics
Customer Service
Special advice
Tools/Equipment
Fluids, lubricants, adhesive
Torque settings
Repair time
Instructions
Content
Description
Legend
Location
Dataflow
Diagram
PIN
Location
Instructions
Body Panels and Closures / Panels / Bodyside Assembled / DA-RM-02A051-03-002 - Remove/Install bodyside - Lower
Preparation work
1.
DA-RM-01A001-00-001 - Secure/Lift vehicle on platform
2.
DA-RM-04B005-01-001 - Remove/Install wheel - Rear
3.
DA-RM-03A076-02-001 - Remove/Install wheel arch liner - Rear
4.
DA-RM-03A075-05-002 - Remove/Install floor panel - Rear extension
5.
DA-RM-02A051-03-004 - Remove/Install panel - Side duct finisher
Remove bodyside - Lower
Care Point:
Risk of paint damage. Protect surrounding area.
Care Point:
Make sure vehicle is in sleep mode or the battery is disconnected.
Care Point:
Shims may be fitted behind the bodyside - Lower
1.
Remove lower bolt (1).
(M6x16) 8 Nm
2.
Remove front inner bolts (2).
(M6x12) 5 Nm
3.
Remove rear inner bolt (3).
(M6x12) 5 Nm
4.
Release and remove bodyside lower from vehicle.
Install bodyside - Lower
Care Point:
Make sure all shims are fitted in the correct position behind the bodyside - lower
Care Point:
Inspect and replace damaged clips.
1.
Install components in reverse order.
Care Point:
The procedure below must be claimed separately if you make a warranty claim.
2.
Check gap and flush.
DA-RM-02A051-00-001 - Gap and flush - Check and adjust - Panels
.
V. 1.10
© 2011 | McLaren
Note