Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
      Exterior Ornamentation
      Glazing - Exterior
      Lights
      Wipers and Washer System
      Ducts, Vents and Floors
        Front Ducts and Vents
        Side Ducts and Vents
        Front Non-structural Floors
        Rear Non-structural Floors
          DA-RM-03A075-05-001 - Remove/Install floor panel - Diffuser
          DB-RM-03A075-05-001 - 765 LT Remove/Install Floor panel - Diffuser
          DA-RM-03A075-05-002 - Remove/Install floor panel - Rear extension
      Liners and NVH
      HVAC
    Chassis
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Body Exterior / Ducts, Vents and Floors / Rear Non-structural Floors / DA-RM-03A075-05-002 - Remove/Install floor panel - Rear extension
Preparation work
1.     
Remove floor panel - Rear extension
 
Care Point:
Make sure that the fuel filler drain hose does not become detached from the fuel filler bowl whilst carrying out this procedure.
Care Point:
The fuel filler drain hose will only be attached to the left hand floor panel - rear extension.
 
1.  
Remove jubilee clip.
 
2.  
Detach hose.
 

3.  
Remove bolts (1).(M6x20) 5 Nm
 
4.  
Remove bolt (2). (M6x16) 4 Nm
 
5.  
Remove bolt (3).(M6x16) 5 Nm
 
6.  
Remove bolts (4).(M6x16) 5 Nm
 
7.  
Remove floor panel - Rear lower extension.
 
Install floor panel - Rear extension
 
Care Point:
Make sure the fuel filler drain hose is fitted securely to the fuel filler bowl, and also the left hand floor panel - rear extension before installing all pre-work components.
 
1.  
Install components in reverse order.
 
   
   
   Note