Repair instructions
    Body Structures
    Body Panels and Closures
      Panels
        Body Panels Service Procedures
        Rear Panels
        Front Panels
        Bodyside Assembled
          DA-RM-02A051-03-001 - Remove/Install bodyside - Upper - Left
          DA-RM-02A051-03-002 - Remove/Install bodyside - Lower
          DA-RM-02A051-03-003 - Remove/Install panel - Dirty air duct
          DA-RM-02A051-03-004 - Remove/Install panel - Side duct finisher
          DA-RM-02A051-03-005 - Remove/Install panel - Aero bridge
          DA-RM-02A051-03-006 - Remove/Install heatshield - Airbrake
          DA-RM-02A051-03-007 - Remove/Install bodyside - Upper - Right
          DA-RM-02A051-03-008 - Remove/Install Panel - Hinge cover - Upper
        Engine Bay Panels
      Closures
      Active Aero
      Glazing - Closures and Dynamic
    Body Exterior
    Chassis
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Body Panels and Closures / Panels / Bodyside Assembled / DA-RM-02A051-03-003 - Remove/Install panel - Dirty air duct
Preparation work
1.     
2.     
3.     
Remove panel - Dirty air duct
 
Care Point:
Make sure vehicle is in sleep mode or the battery is disconnected.
Care Point:
Lift airbrake manually to allow clearance.
 
1.  
Remove bolt (1).(M6x12) 5 Nm
 
2.  
Detach clips and remove duct (2).
 
Install panel - Dirty air duct
1.  
Install components in reverse order.
 
   
   
   Note