Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
      Heat Insulation
      Engine
      Engine Air Systems
        Engine Air Systems Service Procedures
        Air Intake Low Pressure System
          DA-RM-05F002-01-001 - Remove/Install air filter
          DA-RM-05F002-01-002 - Remove/Install Airbox
          DA-RM-05F002-01-003 - Remove/Install sensor - Mass Air Flow (MAF)
          DA-RM-05F002-01-004 Remove/Install duct - airbox to clean air duct
          DA-RM-05F002-01-005 - Remove/Install duct - Clean air
          DA-RM-05F002-01-006 - Remove/Install duct - Clean air duct to turbo charger
          DA-RM-05F002-01-007 - Install Heat shield - Duct - Clean air
        Air Intake High Pressure System
        Charge Air Cooling System
        Intake Sound Generator (ISG) System
      Engine Oil System
      Engine Cooling System
      Engine Ancillaries
      Engine Mounting
      Transmission
      Transmission Cooling System
      Transmission Mounting
      Driveshafts
      Exhaust
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Powertrain / Engine Air Systems / Air Intake Low Pressure System / DA-RM-05F002-01-005 - Remove/Install duct - Clean air
Preparation work
1.     
2.     
3.     
4.     
Remove duct - Clean air
1.  
Disconnect MAF sensor electrical connector and detach harness from duct.
 

2.  
Release clips (1).
 
3.  
Remove bolts (2). (M6x30) 10 Nm
 
4.  
Remove duct from vehicle.
 
Install duct - Clean air
1.  
Always install the duct heat shield. Refer to DA-RM-05F002-01-007 - Install Heat shield - Duct - Clean air.
 
2.  
Install components in reverse order.
 
   
   
   Note