Preparation work
| 1. | |
| 2. | Care Point: Disconnect 12V battery during Remove/Install seat procedure.
|
| 3. | Care Point: Do the two sides.
|
| 4. | Care Point: Do the two sides.
|
| 5. | Care Point: Do the two sides.
|
| 6. | Care Point: Do the two sides.
|
| 7. | |
| 8. | |
| 9. | |
| 10. | Care Point: Do the two sides.
|
| 11. | |
| 12. | |
| 13. | |
| 14. | |
| 15. | |
| 16. | |
| 17. | |
| 18. | Care Point: When removing the facia, also remove the right hand display control unit bracket.
|
| 19. | |
| 20. | |
| 21. | |
| 22. | |
| 23. | Care Point: Do the two sides.
|
| 24. | Care Point: Disconnect body controller only.
|
| 25. | |
Remove Steering column - Upper - Manual
| 1. | Move the bracket (2) to the side.
| | | 
|
| | | Care Point: | Always replace the bolts. Refer to the Spare Parts Catalogue (SPC) for part numbers.
|
| Care Point: | Refer to the installation procedure for the torque sequence.
|
| | | 2. | Remove the bolts (1) and discard.
| | | 
|
| | | Care Point: | Always replace the bolts. Refer to the SPC for part numbers.
|
| Care Point: | Refer to the installation procedure for the torque sequence.
|
| | | 3. | Remove the bolts (1) and discard.
| | | 
|
| 4. | Remove the upper steering column (1) in the direction shown.
| | | 
|
Install Steering column - Upper - Manual
| | | Care Point: | When you install fixings to the cross car beam you must only install them by hand. Do not use power tools.
|
| Care Point: | Make sure that all bolts fitted are not cross threaded before tightening. Any damage caused to the threads will require the cross car beam to be replaced as no filing, drilling, or tapping can be carried out on the beam.
|
| | | 1. | Install the bolts by hand.
| | | 2. | Install the remaining components in reverse order.
| | | 3. | Check the steering column functionality.
| | | 
|