Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
    Interior
      Interior Systems
        Facia
        Facia Console
        Tunnel Console
          DA-RM-08N001-04-001 - Remove/Install tunnel console
          DA-RM-08N001-04-002 - Remove/Install HVAC shroud
        Driver Mirror
        Seat Assembly
        Seat Assembly - Sport
        Lower and Rear Trim
        Upper Trim
        Sunvisor
        Door Casing
      Interior Restraints
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Interior / Interior Systems / Tunnel Console / DA-RM-08N001-04-001 - Remove/Install tunnel console
Preparation work
1.     
2.     
3.     
Care Point: Remove both sides.
4.     
Care Point: Remove both sides.
5.     
6.     
7.     
8.     
Care Point: Remove both sides.
9.     
10.    
11.    
Remove tunnel console
1.  
Remove tunnel mats.
 

2.  
Remove bolts (1). (M5x16) 2 Nm
 
3.  
Remove screws (2). (4.2x16) 2 Nm
 
4.  
Remove bolts (3) and detach the tunnel bracket. (M6x16) 2 Nm
 
5.  
Remove bolts (4). (M5x12) 2 Nm
 
6.  
Remove bolts (5). (M5x12) 2 Nm
 
7.  
Lift rear of tunnel console, disconnect the USB and tunnel bin electrical connectors.
 
8.  
Lift front of tunnel console, disconnect keyless go antenna and 12V accessory socket electrical connectors.
 
9.  
Remove tunnel console from vehicle.
 
Install tunnel console
 
Care Point:
If replacing tunnel console.
 
1.  
Remove and transfer over:
12V Accessory socket
 
2.  
Install components in reverse order.
 
3.  
Check functionality of all electrical components and switches.
 
   
   
   Note