Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
    Interior
      Interior Systems
        Facia
        Facia Console
          DA-RM-08N001-02-001 - Remove/Install bezel - Switch - Aero - Eco Start/Stop - Active - Powertrain Dynamic - Handling Dynamic
          DA-RM-08N001-02-002 - Remove/Install finishers - Facia console
          DA-RM-08N001-02-003 - Remove/Install face plate - Facia Console
          DA-RM-08N001-02-004 - Remove/Install switch carrier - Facia Console
          DA-RM-08N001-02-005 - Remove/Install armature - Facia console
        Tunnel Console
        Driver Mirror
        Seat Assembly
        Seat Assembly - Sport
        Lower and Rear Trim
        Upper Trim
        Sunvisor
        Door Casing
      Interior Restraints
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Interior / Interior Systems / Facia Console / DA-RM-08N001-02-003 - Remove/Install face plate - Facia Console
Preparation work
1.     
2.     
3.     
4.     
Remove face plate - Facia Console
1.  
Remove fixings (1).(M4x16) 3 Nm
 
 
Care Point:
Risk of component damage:Upper clips tight. Make sure face plate is not pulled back and damage to switches or connectors can occur.
Care Point:
Do not lever against the centre display. Apply masking tape where required.
 
2.  
Detach clips (2)
 
3.  
Partially remove face plate.
 
4.  
Disconnect electrical connectors.
 
5.  
Remove face plate.
 
 
Care Point:
If replacing face plate.
 
6.  
Transfer over switches and bezel to replacement face plate:
 
Install face plate - Facia Console
 
Care Point:
Replace any damaged clips.
 
1.  
Install components in reverse order.
 
   
   
   Note