Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
      Wiring Harness
      Electrical Systems
        Interior Switches
          DA-RM-07M002-01-001 - Remove/Install switch - Door release / Window control
          DA-RM-07M002-01-002 - Remove/Install switch - Electronic park brake (EPB)
          DA-RM-07M002-01-003 - Remove/Install switch - Master light control / Mirror control
          DA-RM-07M002-01-004 - Remove/Install switch - Hazard - Launch
          DA-RM-07M002-01-005 - Remove/Install switch - Bonnet Release - Master Lock - Display Deployment
           DA-RM-07M002-01-006 - Remove/Install switch - Engine Stop/Start - Centre Display
          DA-RM-07M002-01-007 - Remove/Install switch - Aero - Eco Start/Stop - Active - Powertrain Dynamic - Handling Dynamic
          DA-RM-07M002-01-008 - Remove/Install switch - Drive - Neutral - Reverse
          DA-RM-07M002-01-009 - Remove/Install control panel - Auxiliary
          DA-RM-07M002-01-010 - Remove/Install control panel - Overhead
        Door Control System
        Body Control System
        Alarm System
        Occupant Restraint Controller System
        Keys and Passive Entry System
        Network ECUs
        Steering Column Module
        Parking Assistance System
        Rain and Light Sensor
        Tyre Pressure Monitoring System
      Electrical Hardware
      Infotainment
      Electrical Misc
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Electrical / Electrical Systems / Interior Switches / DA-RM-07M002-01-006 - Remove/Install switch - Engine Stop/Start - Centre Display
Preparation work
1.     
2.     
3.     
4.     
5.     
Remove switch - Engine Stop/Start - Centre Display
 
Care Point:
Removal procedure for either switch is identical.
Care Point:
Torque value of fixings differs between switchpacks.
 
1.  
Remove screws:
Switch - Engine Stop/Start (1). (M3x12) 2 Nm
Centre Display Switchpack (2).(M3x8) 1 Nm
 
2.  
Remove switch/es (3) from face plate.
 
Install switch - Engine Stop/Start - Centre Display
1.  
Install components in reverse order.
 
2.  
Check functionality.
 
3.  
Read out and clear error memory.
 
   
   
   Note