Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
    Interior
      Interior Systems
        Facia
          DA-RM-08N001-01-001 - Remove/Install facia
          DA-RM-08N001-01-002 - Remove/Install cross car beam
          DA-RM-08N001-01-003 - Remove/Install closure panel - Facia
          DA-RM-08N001-01-004 - Remove/Install ornament wing - Centre - Facia
          DA-RM-08N001-01-005 - Remove/Install air vent - Facia
          DA-RM-08N001-01-006 - Remove/Install Air vent - Face level fixed - Facia
        Facia Console
        Tunnel Console
        Driver Mirror
        Seat Assembly
        Seat Assembly - Sport
        Lower and Rear Trim
        Upper Trim
        Sunvisor
        Door Casing
      Interior Restraints
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Interior / Interior Systems / Facia / DA-RM-08N001-01-004 - Remove/Install ornament wing - Centre - Facia
Remove ornament wing - Centre - Facia
 
Care Point:
Risk of component damage - Apply masking tape to protect facia.
 
1.  
Remove the lower screw (1).(M3.5x12) 1.5 Nm
 
 
Care Point:
Risk of component damage. Upper trim clips are tight. Damage to trim may occur. Trim clip locations shown on graphic (2).
 
2.  
Lift trim (3) upwards from facia to remove.
 
Remove ornament wing - Centre - Facia
 
Care Point:
Replace any damaged clips.
 
1.  
Install components in reverse order.
 
   
   
   Note