720S

1.	DA-RM-03A071-07-002 - Remove/Install access hatch - Luggage bin
2.	Care Point: Disconnect 12V battery during Remove/Install seat procedure. DA-RM-07M003-00-001 - Disconnect/Connect Li-ion battery
3.	Care Point: Remove both sides. DA-RM-08N001-07-001 - Remove/Install seat
4.	Care Point: Remove both sides DA-RM-08N001-09-004 - Remove/Install duct - Demist
5.	Care Point: Remove both sides DA-RM-08N001-09-001 - Remove/Install trim - A-Pillar
6.	Care Point: Remove both sides DA-RM-08N001-08-001 - Remove/Install trim - B-pillar
7.	DA-RM-08N001-08-009 - Remove/Install retention bar - Luggage
8.	DA-RM-08N001-08-008 - Remove/Install carpet / cover - Rear
9.	DA-RM-08N001-01-004 - Remove/Install ornament wing - Centre - Facia
10.	Care Point: Remove both sides DA-RM-08N001-04-002 - Remove/Install HVAC shroud
11.	DA-RM-07M002-07-001 - Remove/Install electronic control unit (HVAC)
12.	DA-RM-07M002-07-002 - Remove/Install electronic control unit - SCUG
13.	DA-RM-08N001-02-002 - Remove/Install finishers - Facia console
14.	DA-RM-08N001-02-003 - Remove/Install face plate - Facia Console
15.	DA-RM-07M021-05-002 - Remove/Install display unit - Centre
16.	DA-RM-08N001-02-004 - Remove/Install switch carrier - Facia Console
17.	DA-RM-08N001-04-001 - Remove/Install tunnel console
18.	Care Point: When removing the facia, also remove the right hand display control unit bracket. DA-RM-07M021-04-001 - Remove/Install control unit - Displays
19.	DA-RM-08N002-01-001 - Remove/Install airbag - Steering wheel
20.	DA-RM-08N002-06-001 - Remove/Install steering wheel
21.	DA-RM-07M021-05-001 - Remove/Install display unit - Driver
22.	DA-RM-07M002-08-001 - Remove/install Mantel row module (MRM)
23.	Care Point: Remove both sides. DA-RM-08N001-01-003 - Remove/Install closure panel - Facia
24.	Care Point: Disconnect body controller only. DA-RM-07M002-03-001 - Remove/Install electronic control unit - Body control / Security body control
25.	DA-RM-08N001-01-001 - Remove/Install facia

Remove antenna - Navigation - GPS

1.	Disconnect electrical connector (1).
2.	Detach antenna (2) from panel.

Install antenna - Navigation - GPS

Care Point:

Remove excess adhesive.

Cleaning mounting area with BETACLEAN 3900. Allow to flash dry.

Prime mounting area with 3M 4298 UV. Allow to flash dry.

Install components in reverse order.

Check functionality.

V. 1.10

Note