Repair instructions
    Body Structures
    Body Panels and Closures
      Panels
      Closures
      Active Aero
        Rear Active Aero Panels
        Rear Active Aero Mechanisms
          DA-RM-02A053-04-001 - Remove/Install mechanism - Airbrake
          DA-RM-02A053-04-002 - Remove/Install position sensor - Airbrake
      Glazing - Closures and Dynamic
    Body Exterior
    Chassis
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
Instructions
Body Panels and Closures / Active Aero / Rear Active Aero Mechanisms / DA-RM-02A053-04-001 - Remove/Install mechanism - Airbrake
Preparation work
1.     
2.     
3.     
4.     
Care Point: Remove both sides.
5.     
Care Point: Remove both sides.
6.     
7.     
Care Point: Remove both sides.
8.     
9.     
Care Point: Remove both sides.
10.    
Care Point: Remove both sides.
11.    
Care Point: Remove both sides.
12.    
Care Point: Remove both sides.
13.    
Care Point: Remove both sides.
14.    
15.    
16.    
17.    
18.    
19.    
Care Point: Remove both sides.
20.    
21.    
WARNING!
 
Possible fluid spills from vehicle systems during repairs or maintenance.
Risk of thermal incidents, slip hazards, corrosion of electrical components, failure of electrical or mechanical components or unwanted odours.
Always limit fluid spills and fully clean the spilled fluid after repairs or maintenance.
 
Remove mechanism - Airbrake
1.  
Remove fixings (1). (M4x15) 8 Nm
 
2.  
Detach hoses (2).
 
3.  
Disconnect electrical connector (3).
 
4.  
Remove fixings (4). (M8x50) 30 Nm
 
5.  
Remove fixings (5). (M6x80) 10 Nm
 
6.  
Remove part (6).
 
Install mechanism - Airbrake
 
Care Point:
Make sure that suspension and rear airbrake mechanism hoses are correctly installed.
 
1.  
Install components in reverse order.
 
   
   
   Note