Preparation work
| 1. | |
| 2. | |
| 3. | |
| 4. | |
| 5. | |
| 6. | |
| 7. | |
| 8. | |
| 9. | |
| 10. | |
| 11. | |
| 12. | |
| 13. | |
| 14. | |
| 15. | |
| 16. | |
| 17. | |
| 18. | |
| 19. | |
Remove harness - Transmission
| 1. | Disconnect control unit - Transmission connectors (1) and release the wiring harness retaining clips from the airbox.
| | | 
|
| 2. | Disconnect the transmission temperature sensor (2).
| | | 3. | Disconnect the transmission wiring harness from the valve block (3).
| | | 
|
| 4. | Disconnect the airbrake electrical connectors (4).
| | | 5. | Disconnect the gear shaft speed sensors electrical connectors (5).
| | | 
|
| 6. | Disconnect the output shaft speed sensor electrical connector (6).
| | | 
|
| 7. | Disconnect electrical connector (7).
| | | 8. | Disconnect electrical connector (8).
| | | 9. | Detach all remaining wiring harness clips from the transmission and the rear frame.
| | | 10. | Remove the harness - Transmission.
| | | 
|
Install harness - Transmission
| 1. | Install components in reverse order.
| | | 2. | Read out and clear error memory.
| | |