Preparation work
| 1. | |
| 2. | |
| 3. | Care Point: Remove both sides.
|
| 4. | |
| 5. | |
 WARNING!
| |
Possible fluid spills from vehicle systems during repairs or maintenance.
Risk of thermal incidents, slip hazards, corrosion of electrical components, failure of electrical or mechanical components or unwanted odours.
Always limit fluid spills and fully clean the spilled fluid after repairs or maintenance.
| |
Remove sensor - Cam phaser
| |
| | | 1. | Disconnect and lay aside the ISG hose (1).
| | | 
|
| |
| | | 2. | Release hose from the retaining bracket (1).
| | | 
|
| 
|
| | | Care Point: | Procedure for removal of cam phaser sensor is identical for both sides of the vehicle from this point.
RH side is shown.
|
| | | 4. | Disconnect the electrical connector (3).
| | | 5. | | | | 6. | Remove the sensor - Cam phaser.
| | | 
|
Install sensor - Cam phaser
| | | Care Point: | If O-ring is damaged, replace sensor - Camshaft phaser.
|
| | | 1. | | | | 2. | Install components in reverse order.
| | | 3. | Read out and clear error memory.
| | |