Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
      Exterior Ornamentation
        Front Bumper
          DA-RM-03A071-01-001 - Remove/Install bumper - Front
          DA-RM-03A071-01-002 - Remove/Install splitter - Front bumper
          DA-RM-03A071-01-003 - Remove/Install bezel - Headlamp
          DA-RM-03A071-01-004 - Remove/Install panel - LTR side exit
          DA-RM-03A071-01-005 - Install license plate plinth - Front
        Front Trim
        Filler Bowls and Covers
        Luggage
        Rear Trim
        Rear Finishers and Grilles
        Rear Bumper
      Glazing - Exterior
      Lights
      Wipers and Washer System
      Ducts, Vents and Floors
      Liners and NVH
      HVAC
    Chassis
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Body Exterior / Exterior Ornamentation / Front Bumper / DA-RM-03A071-01-004 - Remove/Install panel - LTR side exit
Preparation work
1.     
2.     
Care Point: Remove both sides.
3.     
Care Point: Remove both sides.
4.     
5.     
Care Point: Remove both sides.
6.     
7.     
8.     
9.     
Care Point: Remove both sides.
10.    
Care Point: Remove both sides.
11.    
Remove LTR side exit
 
Care Point:
Apply protective tape to the surrounding area.
Care Point:
Vehicles fitted with carbon fibre option LTR side exits will have an additional retaining clip at position ©).
 
1.  
Remove retaining clips (1).
 
2.  
Remove LTR side exit panel from the bumper panel.
 
Install LTR side exit
 
Care Point:
Inspect and replace damaged clips.
 
1.  
Install components in reverse order.
 
 
Care Point:
The procedures below must be claimed separately if you make a warranty claim.
 
2.  
Check and adjust the headlamp aim.DA-RM-03A073-00-001 - Adjust headlamp
 
3.  
Check camera alignment, adjust if required.DA-RM-07M021-00-001 - Calibrate 360 camera system
 
   
   
   Note