720S

Special advice

Tools/Equipment

Fluids, lubricants, adhesive

Content

Description

Legend

Location

Dataflow

Diagram

Location

Instructions

Body Panels and Closures / Panels / Engine Bay Panels / DA-RM-02A051-08-004 - Remove/Install heatshield - Deck vent rear

Preparation work

1.	DA-RM-01A001-00-001 - Secure/Lift vehicle on platform
2.	DA-RM-03A071-07-002 - Remove/Install access hatch - Luggage bin
3.	DA-RM-07M003-00-001 - Disconnect/Connect Li-ion battery
4.	Care Point: Remove both sides. DA-RM-04B005-01-001 - Remove/Install wheel - Rear
5.	Care Point: Remove both sides. DA-RM-03A076-02-001 - Remove/Install wheel arch liner - Rear
6.	DA-RM-03A075-05-001 - Remove/Install floor panel - Diffuser
7.	DA-RM-02A053-03-001 - Remove/Install panel - Airbrake
8.	Care Point: Remove both sides. DA-RM-03A075-05-002 - Remove/Install floor panel - Rear extension
9.	Care Point: Remove both sides. DA-RM-02A051-03-004 - Remove/Install panel - Side duct finisher
10.	Care Point: Remove both sides. DA-RM-02A051-03-003 - Remove/Install panel - Dirty air duct
11.	Care Point: Remove both sides. DA-RM-02A051-03-002 - Remove/Install bodyside - Lower
12.	Care Point: Remove both sides. DA-RM-02A051-03-005 - Remove/Install panel - Aero bridge
13.	Care Point: Detach from fuel filler bowl. DA-RM-04K001-02-001 - Remove/Install fuel filler neck
14.	Care Point: Remove both sides. DA-RM-02A051-03-001 - Remove/Install bodyside - Upper - Left
15.	DA-RM-03A071-10-001 - Remove/Install bumper assembly - Rear
16.	Care Point: Remove both sides. DA-RM-03A071-09-001 - Remove/Install grille - Rear bumper
17.	DA-RM-02A051-03-006 - Remove/Install heatshield - Airbrake
18.	DA-RM-05E001-02-002 - Remove/Install heatshield - Muffler - Upper

Remove heatshield - Deck vent rear

1.	Remove nuts (2). (M5) 4.5 Nm
2.	Remove bolts (1). (M6x12) 5 Nm

3.	Remove bolts (3). (M6x16) 8 Nm
4.	Remove bolts (4). (M5x12) 5 Nm
5.	Remove heatshield (5) from vehicle.

Install heatshield - Deck vent rear

Care Point:

Make sure a washer is fitted with airguide bolts (3).

Install components in reverse order.