Preparation work
| 1. | |
| 2. | |
| 3. | |
| 4. | |
| 5. | |
| 6. | Care Point: Remove both sides.
|
| 7. | Care Point: Remove both sides.
|
| 8. | |
| 9. | Care Point: Remove both sides.
|
| 10. | Care Point: Remove both sides. Remove if replacing bumper panel or LTR side duct, otherwise disconnect only.
|
| 11. | |
Remove light - Signal lamp
| | | Care Point: | Apply protective tape to the surrounding area.
|
| | | 1. | Disconnect electrical connector
| | |
|
| 2. | | | | | | Care Point: | Inner nut (2) is additionally secured with a dome nut.
|
| | | 3. | | | | 4. | Remove light - Signal lamp.
| | | 
|
Install light - Signal lamp
| | | Care Point: | Hand tighten fixings, then torque in the following sequence.
Bolt (1).
Outer nut (2).
Inner nut (2).
Dome nut over inner nut (2).
|
| | | 1. | Install components in reverse order.
| | | 2. | Check functionality of lamp
| | | | | Care Point: | The procedures below must be claimed separately if you make a warranty claim.
|
| | | 3. | | | | 4. | | | |