| | | Care Point: | Replace seatbelt mounting bolt if damaged.
|
| Care Point: | Make sure seatbelt is fitted correctly.
|
| |
| 1. | Install components in reverse order.
| |
| | | Care Point: | Carry out steps 2 to 12, if a replacement passenger seat, IEE capacitance mat, Occupant Classification System module (Passenger seat) or Occupant restraint controller is fitted.
|
| |
| 2. | Connect McLaren Diagnostic System.
| |
| 3. | Proceed to Diagnostic Toolbox.
| |
| 4. | Select Occupant Restraint Controller (ORC).
| |
| 5. | Access Sequences section.
| |
| 6. | Carry out Configure Occupant Classification System.
| |
| | | Care Point: | Important:When reprogramming Seat Control Module, it is imperative both external doors are closed and remain closed during this process and for an additional 30 seconds after completion.
Do not operate the seat control switches during programming.
|
| Care Point: | Carry out steps 7 to 12, if a replacement seat was installed, or the Li-ion battery was not disconnected before the seat was removed.
|
| |
| 7. | Select Seat Control Module (SCML or SCMR).
| |
| 8. | Access Reprogramming.
| |
| | | Care Point: | If update not available, proceed to step 10.
|
| |
| 9. | Check if software update is available, update as required.
Wait for 30 seconds once complete.
| |
| 10. | Access Sequences section.
| |
| 11. | Carry out MDS Seat Calibration.
| |
| 12. | Cycle the ignition.
| |
| 13. | Check out a functionality test.
| |