720S

1.	DA-RM-03A071-07-002 - Remove/Install access hatch - Luggage bin
2.	DA-RM-07M003-00-001 - Disconnect/Connect Li-ion battery
3.	DA-RM-08N001-07-001 - Remove/Install seat

Remove switch pack - Seat - Hybrid

Care Point:

The procedure outlined below refers to the switch pack found on a drivers hybrid seat.

For instructions on removal of a full electric seat switch pack, refer to procedure DA-RM-08N001-07-002 - Remove/Install switch pack - Seat - Electric.

Passenger side manual seats do not have a switch pack.

Care Point:

Risk of component damage: Do not place seat assembly on a hard surface.

Apply masking tape (M) to the valance (1) at the area shown.

Remove screw (2). (M4x8) 2.5 Nm

3.	Disconnect electrical connector (3).
4.	Remove screw (4). (M4x8) 2.5 Nm

5.	Detach trim clips (5) from seat frame.
6.	Remove valance (1) from seat assembly with switch pack (6) attached.

Care Point:

Do not attempt to remove switch pack bezel, as it is bonded to the valance.

Care Point:

Clips are on both sides of the switch pack.

Release switch pack (6) from bezel by pressing in clips (7).

Install switch pack - Seat - Hybrid

Care Point:

Inspect and replace trim clips where required.

Care Point:

If seat control unit is being replaced or updated, make sure switch pack is installed first.

Install components in reverse order.

Check functionality.

V. 1.5