Repair instructions
    Body Structures
    Body Panels and Closures
      Panels
      Closures
        Closures Service Procedures
        Bonnet Structure
        Bonnet Latch
        Door Structure
          DA-RM-02A052-05-001 - Remove/Install door
          DA-RM-02A052-05-002 - Remove/Install applique - Door
          DA-RM-02A052-05-003 - Remove/Install winglet - Door
          DA-RM-02A052-05-004 - Remove/Install aero duct - Door
          DA-RM-02A052-05-005 - Remove/Install blade - Door
          DA-RM-02A052-05-006 - Remove/Install stone deflector - Door
          DA-RM-02A052-05-007 - Remove/Install Mesh - Aero duct - Door
          DA-RM-02A052-05-008 - Replace Door
          DA-RM-02A052-05-009 - Remove/Install Access panel - Door
          DA-RM-02A052-05-010 - Remove/Install Support - Door - Secondary
        Door Hinge
        Door Latch
        Side Mirrors
        Tailgate/Engine Cover Structure
        Closure Seals
      Active Aero
      Glazing - Closures and Dynamic
    Body Exterior
    Chassis
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Body Panels and Closures / Closures / Door Structure / DA-RM-02A052-05-009 - Remove/Install Access panel - Door
Remove Access panel - Door
1.  
Break the bond of the adhesive tape (1) to remove the access panel (2).
 
Install Access panel - Door
1.  
Remove the remaining adhesive tape from the door and access panel bond paths.
 
2.  
Clean the door and access panel adhesive tape bond paths. Use BETACLEAN 3900.
 

 
Care Point:
Only do the step that follows if you install a used panel.
 
3.  
Apply 3M PT1100 Tape to the access panel.
 
4.  
Remove the adhesive tape backing and install the access panel.
 
5.  
Push the access panel firmly in position to make sure that the bond is satisfactory.
 
   
   
   Note