Preparation work
| 1. | |
| 2. | |
| 3. | Care Point: Remove both sides.
|
| 4. | |
| 5. | |
| 6. | |
| 7. | Care Point: Vehicles fitted with 12 speaker (High Line) audio system.
|
Overview
| 1. | The Navigation Maps for European, Federal and Japanese markets will be pre-installed onto the control unit.
For all other markets, the Navigation Maps are contained on an SD memory card. During the PDI (Pre-delivery Inspection) the SD card must be taken from the Accessory bag and installed into the control unit.
This will not be the case should a map update be released, where this will be contained on an SD memory card in all cases.
| | | 2. | Replacement control units are not supplied with a new SD card, and as such this must be carried over to the new part.
| | |
Remove control unit - Infotainment
| 1. | Unclip the wiring harness from the bracket.
| | | 2. | Disconnect the electrical connectors from the control unit and PDC speaker (where fitted).
| | |
|
| 3. | | | | 4. | Remove the bracket and the control unit (2) from vehicle.
| | | 
|
| | | Care Point: | Proceed only if replacing the control unit.
|
| Care Point: | On both sides of assembly.
|
| | | 5. | | | | 6. | Separate the bracket from the control unit (2).
| | | | | Care Point: | If the replacing control unit.
Make sure that the SD card is either securely stored during replacement or immediately transferred to the replacement part.
|
| | | 7. | Remove the Navigation Maps SD card.
| | | 
|
Install control unit - Infotainment
| 1. | Install the components in reverse order.
| | | | | Care Point: | If an update is not available, proceed to step 3.
|
| Care Point: | The Advance Drive Interface (ADI) software links are listed in a Knowledge Article (KA). Refer to KA-01234.
|
| | | 2. | Download the latest ADI software to a USB pen drive.
Follow the steps in the KA-01234 to update the control unit.
| | | 3. | Go to Sequences in the ADI.
| | | 4. | Do the Align Car Configuration sequence.
| | | 5. | Do the Programme VIN sequence.
| | | 6. | Do the Set Configuration Defaults sequence.
| | | 7. | Do the Radio Configuration sequence.
| | | | | Care Point: | Where required, check and re-calibrate vehicle camera system.
|
| Care Point: | The procedure below must be claimed separately if you make a warranty claim.
|
| | | 8. | or
| | | 9. | Connect the McLaren Diagnostic System (MDS) and do a Diagnostic Trouble Code (DTC) read and clear.
| | | 10. | Check functionality.
| | |