Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
      Wiring Harness
      Electrical Systems
        Interior Switches
        Door Control System
        Body Control System
        Alarm System
        Occupant Restraint Controller System
        Keys and Passive Entry System
        Network ECUs
        Steering Column Module
        Parking Assistance System
          DA-RM-07M002-10-001 - Remove/Install control unit - Park distance control
          DA-RM-07M002-10-002 - Remove/Install sensor - Parking - Front
          DA-RM-07M002-10-003 - Remove/Install sensor - Parking - Reverse
        Rain and Light Sensor
        Tyre Pressure Monitoring System
      Electrical Hardware
      Infotainment
      Electrical Misc
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Electrical / Electrical Systems / Parking Assistance System / DA-RM-07M002-10-002 - Remove/Install sensor - Parking - Front
Preparation work
1.     
2.     
3.     
Care Point: Remove both sides.
4.     
5.     
6.     
Care Point: Remove both sides.
7.     
Care Point: Remove both sides.
8.     
9.     
Care Point: Remove both sides.
10.    
Care Point: Remove both sides. Remove if replacing bumper panel or LTR side duct, otherwise disconnect only.
11.    
Remove parking sensor - Front
 
Care Point:
Apply protective tape to the surrounding area.
 
1.  
Disconnect electrical connector.
 
2.  
Release retaining tabs (1).
 
3.  
Remove parking sensor.
 
Install parking sensor - Front
 
Care Point:
The sensor - Parking - Front is fitted with a rubber sealing ring (2).
Make sure this is fitted correctly when installing the sensor.
 
1.  
Install components in reverse order.
 
   
   
   Note