Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
      Wiring Harness
      Electrical Systems
        Interior Switches
        Door Control System
        Body Control System
        Alarm System
          DA-RM-07M002-04-001 - Remove/Install electronic control unit - Satellite tracking alarm
          DA-RM-07M002-04-002 - Remove/Install electronic control unit - Alarm and siren (ACU)
          DA-RM-07M002-04-003 - Remove/Install sensor - Anti-tow / Tilt
          DA-RM-07M002-04-004 - Remove/Install sensor - Microwave
          DA-RM-07M002-04-005 - Remove/Install antenna - Satellite tracking - GSM
          DA-RM-07M002-04-006 - Remove/Install antenna - Satellite tracking - GPS
          DA-RM-07M002-04-007 - Remove/Install antenna - Satellite tracking - RF
        Occupant Restraint Controller System
        Keys and Passive Entry System
        Network ECUs
        Steering Column Module
        Parking Assistance System
        Rain and Light Sensor
        Tyre Pressure Monitoring System
      Electrical Hardware
      Infotainment
      Electrical Misc
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Electrical / Electrical Systems / Alarm System / DA-RM-07M002-04-002 - Remove/Install electronic control unit - Alarm and siren (ACU)
Preparation work
1.     
2.     
3.     
Care Point: Do the two sides.
4.     
5.     
6.     
Care Point: Do the two sides.
7.     
Care Point: Do the two sides.
8.     
9.     
Care Point: Do the two sides.
10.    
Care Point: Do the two sides. Remove if replacing bumper panel or LTR side duct, otherwise disconnect only.
11.    
Remove electronic control unit - Alarm and siren (ACU)
1.  
Disconnect electrical connector (1).
 
2.  
Remove nut (2). (M8) 7 Nm
 
3.  
Remove control unit - Alarm and Siren (ACU) (3).
 
Install electronic control unit - Alarm and siren (ACU)
1.  
Install components in reverse order.
 
2.  
Carry out diagnostic check and clear any fault codes.
 
   
   
   Note