720S

Powertrain / Engine Air Systems / Charge Air Cooling System / DA-RM-05F002-03-002 - Remove/Install sensor - Temperature manifold absolute pressure (TMAP) - WCAC

Preparation work

1.	DA-RM-01A001-00-001 - Secure/Lift vehicle on platform
2.	DA-RM-04B005-01-001 - Remove/Install wheel - Rear
3.	DA-RM-03A076-02-001 - Remove/Install wheel arch liner - Rear
4.	DA-RM-02A051-03-004 - Remove/Install panel - Side duct finisher
5.	DA-RM-02A051-03-003 - Remove/Install panel - Dirty air duct
6.	DA-RM-02A051-03-002 - Remove/Install bodyside - Lower
7.	DA-RM-02A051-03-005 - Remove/Install panel - Aero bridge
8.	DA-RM-02A051-03-001 - Remove/Install bodyside - Upper - Left
9.	Care Point: When removing LH side carry on following additional step. DA-RM-03A071-06-001 - Remove/Install fuel filler bowl

Remove sensor - Temperature manifold absolute pressure (TMAP) - WCAC

1.	Disconnect electrical connector (1).
2.	Remove bolt (2).(M6x16) 6 Nm
3.	Remove sensor.

Install sensor - Temperature manifold absolute pressure (TMAP) - WCAC

1.	Install components in reverse order.
2.	Read out and clear error memory.

V. 1.5