Preparation work
| 1. | Care Point: Remove both sides.
|
| 2. | |
| 3. | |
| 4. | |
Remove control unit - Chassis (CCU)
| 1. | Disconnect electrical connectors (1).
| | | 2. | | | | 3. | Remove the control unit - Chassis (CCU).
| | | 
|
Install control unit - Chassis (CCU)
| 1. | Install components in reverse order.
| | | | | Care Point: | Carry out steps 2 to 11 if a new control unit is fitted.
|
| Care Point: | Make sure VCI and MDS batteries are in good condition or connected to external power supply.
|
| | | 2. | Connect McLaren Diagnostic System (MDS).
| | | 3. | Proceed to Diagnostic Toolbox.
| | | 4. | Select Chassis Control Unit (CCU).
| | | 5. | Access reprogramming.
| | | | | Care Point: | If update is not available, proceed to step 7.
|
| | | 6. | Check if a software update is available, update as required.
| | | 7. | Access sequences.
| | | 8. | Carry out Align Car Configuration sequence.
| | | 9. | Carry out Programme VIN sequence.
| | | 10. | Carry out Suspension Pressure Sensor Calibration sequence.
| | | 11. | Carry out Adaptive Damping Calibration sequence.
| | |