Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
      Suspension Front
      Suspension Rear
      Suspension - Systems
        Suspension - Systems Service Procedures
        Suspension Fluid Systems
          DA-RM-04B003-01-001 - Remove/Install automatic pressure monitoring unit (APMU)
          DA-RM-04B003-01-002 - Remove/Install pressure lines - Suspension - Front
          DA-RM-04B003-01-003 - Remove/Install pressure lines - Suspension - Rear
          DA-RM-04B003-01-004 - Remove/Install pressure lines - Nose Lift - Front
          DA-RM-04B003-01-005 - Remove/Install sensor - Accelerometer - Front - Frame
          DA-RM-04B003-01-006 - Remove/Install sensor - Accelerometer - Rear - Frame
          DA-RM-04B003-01-007 - Remove/Install control unit - Chassis (CCU)
      Suspension - Wheels and Tyres Front
      Suspension - Wheels and Tyres Rear
      Brakes Front
      Brakes Rear
      Brakes - Systems
      Brakes - Parking Brake
      Steering
      Fuel Tank
      Fuel System
      Cooling - High Temperature
      Cooling - Low Temperature
      Heating Ventilation & Air Conditioning (HVAC)
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Chassis / Suspension - Systems / Suspension Fluid Systems / DA-RM-04B003-01-006 - Remove/Install sensor - Accelerometer - Rear - Frame
Preparation work
1.     
2.     
3.     
Remove sensor - Accelerometer - Rear - Frame
1.  
Remove nut (1).(M6) 8 Nm
 
2.  
Remove accelerometer.
 
Install sensor - Accelerometer - Rear - Frame
1.  
Install components in reverse order.
 
2.  
Connect McLaren Diagnostic System and proceed to Chassis Control Unit (CCU).
 
3.  
Access Sequences section.
 
4.  
Carry out APMU Sensor Calibration.
 
5.  
Carry out Kinetic Damping System Pressure Sensor Check.
 
6.  
Read out and clear error memory.
 
   
   
   Note