720S

1.	DA-RM-01A001-00-001 - Secure/Lift vehicle on platform
2.	DA-RM-04B005-01-001 - Remove/Install wheel - Rear
3.	DA-RM-03A076-02-001 - Remove/Install wheel arch liner - Rear
4.	DA-RM-03A075-05-001 - Remove/Install floor panel - Diffuser
5.	Care Point: Disconnect only. DA-RM-04B002-02-003 - Remove/Install sensor - Wheel speed - Rear
6.	Care Point: Disconnect only. DA-RM-04B002-02-004 - Remove/Install sensor - Accelerometer - Rear Suspension

Remove wishbone - Rear - Lower

1.	Release lock and detach displacement senor link rod (1).
2.	Remove nut (2) and disconnect the link rod from the lower wishbone. 60 Nm

Care Point:

Support the suspension.

Release bolt (3) and detach the actuator from the lower wishbone. (M10x40) 57 Nm

Remove nut (4) and detach the lower wishbone from the upright. (M14) 90 Nm

Remove bolts (5) and remove the lower wishbone. (M10x30) 57 Nm

Install wishbone - Rear - Lower

Install components in reverse order.

Care Point:

Once vehicle is on ground.

Apply pressure to the top of the wheel, towards vehicle. If excessive inward movement is detected, the upper wishbone ball joint has failed. The upper wishbone will require replacing.

Care Point:

The procedure below must be claimed separately if you make a warranty claim.

Make sure that the suspension geometry is in tolerance.

Refer to DA-RM-04B004-00-001 - Check Suspension Geometry for 720S Coupe.

Refer to DD-RM-04B004-00-001 - Check Suspension Geometry for 720S Spider.

Refer to DB-RM-04B004-00-001 - 765 LT - Check suspension geometry for 765LT Coupe.

Refer to DC-RM-04B004-00-001 - 765 LT Spider - Check suspension geometry for 765LT Spider.

Connect McLaren Diagnostic System, proceed to Diagnostic Toolbox within Chassis Control Unit (CCU).

Access Sequences section.

Carry out Damping Sensor Calibration.

V. 1.8

Note