Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
      Suspension Front
      Suspension Rear
        Damper and Actuator Assemblies Rear
        Uprights Rear
        Transverse Links Rear
          DA-RM-04B002-03-001 - Remove/Install wishbone - Rear - Upper
          DA-RM-04B002-03-002 - Remove/Install wishbone - Rear - Lower
          DA-RM-04B002-03-003 - Remove/Install sensor - Suspension displacement - Rear
          DA-RM-04B002-03-004 - Remove/install ball joint gaiter - Rear
        Road Springs Rear
        Rear Toe Link
      Suspension - Systems
      Suspension - Wheels and Tyres Front
      Suspension - Wheels and Tyres Rear
      Brakes Front
      Brakes Rear
      Brakes - Systems
      Brakes - Parking Brake
      Steering
      Fuel Tank
      Fuel System
      Cooling - High Temperature
      Cooling - Low Temperature
      Heating Ventilation & Air Conditioning (HVAC)
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Chassis / Suspension Rear / Transverse Links Rear / DA-RM-04B002-03-003 - Remove/Install sensor - Suspension displacement - Rear
Preparation work
1.     
2.     
3.     
Remove sensor - Suspension displacement - Rear
1.  
Disconnect electrical connector (1).
 
2.  
Detach gimbal (2).
 
3.  
Remove bolts (3).(M5x10) 5 Nm
 
4.  
Remove displacement sensor.
 
Install sensor - Suspension displacement - Rear
1.  
Make sure ball sockets are tightened to the correct torque.
Upper: 6 Nm
Lower: 6 Nm
 
2.  
Install displacement sensor.
 
 
Care Point:
Make sure catches are correctly locked on gimbal.
Care Point:
Gimbal must be free to articulate easily and smoothly.
 
3.  
Install gimbal (2).
 
4.  
Install components in reverse order.
 
5.  
Connect McLaren Diagnostic System (MDS).
 
6.  
Proceed to Diagnostic Toolbox with Chassis Control Unit (CCU).
 
7.  
Access sequences.
 
8.  
Carry out Adaptive Damping Calibration sequence.
 
   
   
   Note