Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
      Exterior Ornamentation
        Front Bumper
        Front Trim
        Filler Bowls and Covers
        Luggage
        Rear Trim
        Rear Finishers and Grilles
        Rear Bumper
          DA-RM-03A071-10-001 - Remove/Install bumper assembly - Rear
          DA-RM-03A071-10-002 - Remove/Install centre panel - Rear bumper
          DA-RM-03A071-10-003 - Remove/Install extension - Rear bumper
          DA-RM-03A071-10-004 - Install license plate plinth - Rear
      Glazing - Exterior
      Lights
      Wipers and Washer System
      Ducts, Vents and Floors
      Liners and NVH
      HVAC
    Chassis
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Body Exterior / Exterior Ornamentation / Rear Bumper / DA-RM-03A071-10-003 - Remove/Install extension - Rear bumper
Preparation work
1.     
2.     
3.     
4.     
Care Point: Remove both sides.
5.     
Care Point: Remove both sides.
6.     
7.     
Remove extension - Rear bumper
1.  
Remove bolts (1). (M6x12) 5 Nm
 
2.  
Detach clips (2).
 
3.  
Separate extension from bumper assembly (3).
 
Install extension - Rear bumper
1.  
Install components in reverse order.
 
 
Care Point:
The procedures below must be claimed separately if you make a warranty claim.
 
2.  
or
 
   
   
   Note