Overview
| 1. | The procedure below shows fitment of EU plinth. Installation is identical for all plinths, excluding height setting. This will be shown in a table in step 1.
The following fixings are required:
Part number
| Description
| Quantity
|
00RA249
| Nut - M5 - Rawl
| 4
| 00RA064
| Bolt - M5 x 12 - Hex
| 4
|
| | |
Install license plate plinth - Front
| 1. | Measuring from the bottom of the bumper skin (B), measure upwards to locate the bottom edge position for the plinth being installed.
Note: Measurement inclusive of the shape of the bumper.
Once measured, apply a marker (M1) (such as tape) to define bottom edge position.
Plinth
| Measurement (mm)
|
EU
| 40
| Federal
| 60
| Japan
| 32
| China
| 36
|
| | | 2. | Locate the centre line of the bumper skin, apply a marker (M2) (such as tape) to highlight.
| | | 
|
| 3. | Test fit plinth (1) to bumper, and secure using masking tape.
| | | | | Care Point: | Make sure plinth is level before continuing.
|
| | | 4. | Use holes in plinth to mark hole centres (2) in bumper.
| | | 5. | Remove plinth (1) from bumper.
| | | 6. | Remove marker (M1, M2).
| | | | | Care Point: | Do not drill more than 20 mm beyond bumper skin.
|
| | | 7. | Drill four pilot / guide holes (2) into bumper.
| | | 8. | Widen holes (2) drilled to a suitable diameter to fit rawl nuts.
| | | 
|
| 9. | Install rawl nuts (3) to bumper.
| | | 
|
| 
|