Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
      Wiring Harness
        Wiring Harness Service Procedures
        Non-Body Wiring Harness
          DA-RM-07M001-03-001 - Remove/Install Harness - Door
      Electrical Systems
      Electrical Hardware
      Infotainment
      Electrical Misc
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Electrical / Wiring Harness / Non-Body Wiring Harness / DA-RM-07M001-03-001 - Remove/Install Harness - Door
Preparation work
1.     
2.     
3.     
4.     
5.     
6.     
7.     
8.     
9.     
10.    
11.    
12.    
Remove Harness - Door
1.   
Disconnect the electrical connector (1).
Disengage the clips (2).
 
2.   
Disengage the clips (1).
 
3.   
Disconnect the electrical connector (1).
Disengage the clips (2).
 
4.   
Disconnect the electrical connectors (1).
Disengage the clips (2).
 
5.   
Disengage the clips (1).
 
6.   
Disconnect the electrical connectors (1).
Disengage the clip (2).
 
7.   
Disengage the clips (1).
 
 
Care Point:
Risk of Damage. Make sure that you do not close the door on the harness.
 
8.   
Push the grommet (1) through the hole in the direction shown.
 
9.   
Push the grommet (1) through the hole in the direction shown.
Disengage the clip (2).
 
10.  
Disengage the clips (1).
 
11.  
Disconnect the electrical connector (1).
 
12.  
Disengage the clip (1).
 
13.  
Remove the bolt (1) (M6x16) 8 Nm.
Disengage the clips (2).
Disconnect the electrical connector (3).
 
14.  
Push the grommet (1) through the hole in the direction shown.
Remove the harness.
 
Install Harness - Door
1.  
Install the components in reverse order.
 
   
   
   Note