Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
      Wiring Harness
      Electrical Systems
        Interior Switches
        Door Control System
        Body Control System
        Alarm System
        Occupant Restraint Controller System
          DA-RM-07M002-05-001 - Remove/Install sensor - Occupant Restraint - Pressure
          DA-RM-07M002-05-002 - Remove/Install sensor - Occupant restraint - Front impact
          DA-RM-07M002-05-003 - Remove/Install sensor - Occupant restraint - Side impact
          DA-RM-07M002-05-004 - Remove/Install control unit - Occupant restraint controller (ORC)
        Keys and Passive Entry System
        Network ECUs
        Steering Column Module
        Parking Assistance System
        Rain and Light Sensor
        Tyre Pressure Monitoring System
      Electrical Hardware
      Infotainment
      Electrical Misc
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Electrical / Electrical Systems / Occupant Restraint Controller System / DA-RM-07M002-05-002 - Remove/Install sensor - Occupant restraint - Front impact
Preparation work
1.     
Care Point: Remove both sides.
2.     
3.     
4.     
Remove sensor - Occupant restraint - Front impact
1.  
Remove bolt (1).(M6x16) 9 Nm
 
2.  
Disconnect electrical connector (2).
 
3.  
Remove front impact sensor from vehicle.
 
Install sensor - Occupant restraint - Front impact
1.  
Install components in reverse order.
 
2.  
Carry out diagnostic check and clear any fault codes.
 
   
   
   Note