Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
      Wiring Harness
      Electrical Systems
        Interior Switches
        Door Control System
        Body Control System
        Alarm System
          DA-RM-07M002-04-001 - Remove/Install electronic control unit - Satellite tracking alarm
          DA-RM-07M002-04-002 - Remove/Install electronic control unit - Alarm and siren (ACU)
          DA-RM-07M002-04-003 - Remove/Install sensor - Anti-tow / Tilt
          DA-RM-07M002-04-004 - Remove/Install sensor - Microwave
          DA-RM-07M002-04-005 - Remove/Install antenna - Satellite tracking - GSM
          DA-RM-07M002-04-006 - Remove/Install antenna - Satellite tracking - GPS
          DA-RM-07M002-04-007 - Remove/Install antenna - Satellite tracking - RF
        Occupant Restraint Controller System
        Keys and Passive Entry System
        Network ECUs
        Steering Column Module
        Parking Assistance System
        Rain and Light Sensor
        Tyre Pressure Monitoring System
      Electrical Hardware
      Infotainment
      Electrical Misc
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Electrical / Electrical Systems / Alarm System / DA-RM-07M002-04-003 - Remove/Install sensor - Anti-tow / Tilt
Preparation work
1.     
2.     
3.     
Care Point: Remove both sides.
4.     
5.     
6.     
Remove sensor - Anti-tow
1.  
Disconnect electrical connector (1).
 
2.  
Remove bolts (2). (M6x16) 4 Nm
 
 
Care Point:
Record position of the sensor - Anti-tow.
 
3.  
Remove sensor - Anti-tow (3).
 
Install sensor - Anti-tow
 
Care Point:
Make sure the sensor is installed in the recorded position.
 
1.  
Install components in reverse order.
 
2.  
Read out and clear error memory.
 
   
   
   Note