| 1. | Check the tyre pressures when they are at ambient temperature. The correct tyre pressures are shown in the table below.
Front
| Rear
|
2.2 bar
| 2.2 bar
|
| |
| 2. | Start the engine.
| |
| 3. | Set the handling mode to Normal for a minimum of 30 seconds.
| |
| 4. | Set the handling mode to Track for a minimum of 30 seconds.
| |
| 5. | Set the handling mode to Normal for a minimum of 30 seconds.
| |
| 6. | Stop the engine.
| |
| | | Care Point: | The fuel tank must be half full. This weighs approximately 26.5kg. If the fuel tank is not half full, you must adjust the quantity of ballast that you add. The ballast must be installed towards the rear and centre of the cabin as possible.
|
| Care Point: | Before you add ballast, drive the vehicle in the workshop. Make sure that the suspension has become stable.
|
| |
| 7. | Put the vehicle on the wheel alignment ramp.
| |
| 8. | Add ballast to the areas shown in the table below:
Driver seat
| Driver side floor
| Passenger seat
| Passenger side floor
|
25kg
| 12.5kg
| 25kg
| 12.5kg
|
| |