Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
      Suspension Front
        Suspension Service Procedures
        Damper and Actuator Assemblies Front
        Uprights Front
          DA-RM-04B001-02-001 - Remove/Install upright - Front
          DA-RM-04B001-02-002 - Remove/Install Wheel hub assembly with a stub axle - Front
          DA-RM-04B001-02-003 - Remove/Install sensor - Wheel speed - Front
          DA-RM-04B001-02-004 - Remove/Install sensor - Accelerometer - Front suspension
          DA-RM-04B001-02-005 - Remove/Install Wheel hub assembly without a stub axle - Front
          GI-RM-0009 - Install Heatshield - Wheel speed sensor
        Transverse Links Front
      Suspension Rear
      Suspension - Systems
      Suspension - Wheels and Tyres Front
      Suspension - Wheels and Tyres Rear
      Brakes Front
      Brakes Rear
      Brakes - Systems
      Brakes - Parking Brake
      Steering
      Fuel Tank
      Fuel System
      Cooling - High Temperature
      Cooling - Low Temperature
      Heating Ventilation & Air Conditioning (HVAC)
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Chassis / Suspension Front / Uprights Front / DA-RM-04B001-02-004 - Remove/Install sensor - Accelerometer - Front suspension
Preparation work
1.     
2.     
Remove sensor - Accelerometer - Front suspension
1.  
Disconnect electrical connector (1).
 
2.  
Remove bolt (2). (M6x20) 8 Nm
 
3.  
Remove sensor from upright assembly.
 
Install sensor - Accelerometer - Front suspension
1.  
Install components in reverse order.
 
2.  
Connect McLaren Diagnostic System and proceed to Chassis Control Unit (CCU).
 
3.  
Access Sequences section
 
4.  
Carry out APMU Sensor Calibration.
 
5.  
Carry out Kinetic Damping System Pressure Sensor Check.
 
6.  
Read out and clear error memory.
 
   
   
   Note