Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
      Suspension Front
        Suspension Service Procedures
        Damper and Actuator Assemblies Front
        Uprights Front
          DA-RM-04B001-02-001 - Remove/Install upright - Front
          DA-RM-04B001-02-002 - Remove/Install Wheel hub assembly with a stub axle - Front
          DA-RM-04B001-02-003 - Remove/Install sensor - Wheel speed - Front
          DA-RM-04B001-02-004 - Remove/Install sensor - Accelerometer - Front suspension
          DA-RM-04B001-02-005 - Remove/Install Wheel hub assembly without a stub axle - Front
          GI-RM-0009 - Install Heatshield - Wheel speed sensor
        Transverse Links Front
      Suspension Rear
      Suspension - Systems
      Suspension - Wheels and Tyres Front
      Suspension - Wheels and Tyres Rear
      Brakes Front
      Brakes Rear
      Brakes - Systems
      Brakes - Parking Brake
      Steering
      Fuel Tank
      Fuel System
      Cooling - High Temperature
      Cooling - Low Temperature
      Heating Ventilation & Air Conditioning (HVAC)
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
Instructions
Chassis / Suspension Front / Uprights Front / DA-RM-04B001-02-005 - Remove/Install Wheel hub assembly without a stub axle - Front
Preparation work
1.     
2.     
3.     
4.     
5.     
Remove Wheel hub assembly without a stub axle - Front
 
Care Point:
There are two types of wheel hub assembly. Make sure that you install the correct type, refer to the notes in the Spare Parts Catalogue (SPC).
Care Point:
Make sure that you install the type of wheel hub assembly without a stub axle. Refer to the notes in the Spare Parts Catalogue (SPC).
 
1.  
The illustration shows a wheel hub assembly without a stub axle (1).
The illustration shows a wheel hub assembly with a stub axle (2).
 
2.  
Remove the bolts and washers (1). (M12x30) 70 Nm
 
3.  
Remove the wheel hub (2).
 
Install Wheel hub assembly without a stub axle - Front
 
Care Point:
Make sure that the bolts are cleaned and Loctite 2701 is applied.
 
1.  
Install the components in reverse order.
 
   
   
   Note