Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
      Exterior Ornamentation
      Glazing - Exterior
      Lights
      Wipers and Washer System
      Ducts, Vents and Floors
        Front Ducts and Vents
        Side Ducts and Vents
        Front Non-structural Floors
        Rear Non-structural Floors
          DA-RM-03A075-05-001 - Remove/Install floor panel - Diffuser
          DB-RM-03A075-05-001 - 765 LT Remove/Install Floor panel - Diffuser
          DA-RM-03A075-05-002 - Remove/Install floor panel - Rear extension
      Liners and NVH
      HVAC
    Chassis
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Body Exterior / Ducts, Vents and Floors / Rear Non-structural Floors / DA-RM-03A075-05-001 - Remove/Install floor panel - Diffuser
Preparation work
1.     
2.     
Care Point: Remove both sides.
3.     
Care Point: Remove both sides.
Remove floor panel - Diffuser
 
Care Point:
Vehicles fitted with optional carbon fibre diffuser have different fixings. Torque values are identical.
Care Point:
Record position of washers found only on certain fixings.
 
1.  
Remove bolts (1).(M6x16) 6 Nm
 
2.  
Remove bolts (2).(M6x16) 6 Nm
 
3.  
Remove diffuser from vehicle.
 
Install floor panel - Diffuser
 
Care Point:
Inspect and replace any damaged clips.
 
1.  
Install components in reverse order.
 
   
   
   Note