Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
      Heat Insulation
      Engine
      Engine Air Systems
      Engine Oil System
      Engine Cooling System
      Engine Ancillaries
      Engine Mounting
      Transmission
      Transmission Cooling System
      Transmission Mounting
      Driveshafts
      Exhaust
        Link Pipe / Catalyst Assembly
        Muffler and Tail Pipes
          GI-RM-0020 - Clean Exhaust finisher - 570S/720S/750S/Artura
          DA-RM-05H001-02-001 - Remove/Install muffler
          DA-RM-05H001-02-002 - Remove/Install tail pipe finisher
        Exhaust Valve Actuation System
        Lambda Sensors
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Powertrain / Exhaust / Muffler and Tail Pipes / DA-RM-05H001-02-002 - Remove/Install tail pipe finisher
Preparation work
1.     
2.     
3.     
4.     
Care Point: Remove both sides.
5.     
Care Point: Remove both sides.
6.     
7.     
Remove tail pipe finisher
 
Care Point:
Supporting tailpipe.
 
1.  
Release clamp (1).35 Nm
 
Install tail pipe finisher
 
Care Point:
Replace clamp (1).
Care Point:
Make sure tailpipe finisher follows the profile of the rear bumper.
 
1.  
Install components in reverse order.
 

2.  
Check the gap value between tail pipe finisher and bumper (2) is equal to 18mm.
 
   
   
   Note