Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
      Heat Insulation
      Engine
      Engine Air Systems
      Engine Oil System
      Engine Cooling System
      Engine Ancillaries
      Engine Mounting
      Transmission
        Transmission Service Procedures
          DA-RM-05G001-00-001 - Drain/fill fluid - Transmission oil
          DA-RM-05G001-00-002 - Drain/fill fluid - Clutch oil
          DA-RM-05G001-00-003 - Replace Grub screw - Transmission
        Transmission
        Powertrain and Chassis Control Unit
      Transmission Cooling System
      Transmission Mounting
      Driveshafts
      Exhaust
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
Instructions
Powertrain / Transmission / Transmission Service Procedures / DA-RM-05G001-00-003 - Replace Grub screw - Transmission
Preparation work
1.     
2.     
Care Point: Do the left side.
3.     
Care Point: Do the left side.
4.     
Care Point: Do the left side.
5.     
Care Point: Do the left side.
6.     
Care Point: Do the left side.
7.     
Care Point: Do the left side.
8.     
Care Point: Do the left side.
9.     
Care Point: Do the left side.
10.    
Care Point: Do the left side.
Remove Grub screw - Transmission
1.  
Remove the grub screw (1) (M20) 22 Nm.
 
 
Install Grub screw - Transmission
 
1.   
Use a cloth to clean any unwanted sealant from the threads (1).
 
2.   
Put a cloth into the hole (1) to make sure that no sealant or debris enters the transmission housing.
 
 
Care Point:
Make sure that you remove all of the unwanted sealant.
Care Point:
Make sure that no sealant or debris enters the transmission housing.
 
3.   
Use an M20x1.5 thread tap to clean the unwanted sealant from the threads.
 
4.   
Make sure that the tap is turned through 5 full rotations.
 
5.   
Use compressed air to remove the unwanted sealant and debris from the threads (1).
 
6.   
Use a cloth to clean any unwanted sealant from the threads.
 
7.   
Remove the cloth from the hole.
 
 
Care Point:
Always replace the grub screw. Refer to the Spare Parts Catalogue (SPC) for part numbers.
 
8.   
Apply Loctite 510 to the thread of the new grub screw.
 
9.   
Install the new grub screw by hand.
 
10.  
Torque the new grub screw (M20) 22 Nm.
 
 
Care Point:
Risk of damage. You must wait a minimum of 12 hours before you start the vehicle to let the threadlock cure.
 
11.  
Install the remaining components in reverse order.
 
   
   
   Note