Preparation work
| 1. | |
| 2. | Care Point: Remove both sides.
|
| 3. | Care Point: Remove both sides.
|
| 4. | |
Remove light - Fog/Reverse
| 1. | | | | 2. | Release wiring harness clips (2).
| | | 3. | Remove the heat shield (3).
| | | 
|
| 4. | Disconnect electrical connector (4) and release the connector from the frame.
| | | 5. | Guide the wiring harness (5) downwards to release from the bumper rear (6) and the bumper rear support (7).
| | | 
|
| 6. | | | | 7. | Remove the light - Fog/Reverse.
| | | 
|
Install light - Fog/Reverse
| | | Care Point: | Make sure the wiring harness is routed correctly between the bumper rear (6) and the bumper rear support (7).
|
| | | 1. | Install components in reverse order.
| | |