DA-RM-08N001-09-002 - Remove/Install trim - Headliner

  Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
    Powertrain
    Electrical
    Interior
      Interior Systems
        Facia
        Facia Console
        Tunnel Console
        Driver Mirror
        Seat Assembly
        Seat Assembly - Sport
        Lower and Rear Trim
        Upper Trim
          DA-RM-08N001-09-001 - Remove/Install trim - A-Pillar
          DA-RM-08N001-09-002 - Remove/Install trim - Headliner
          DA-RM-08N001-09-003 - Remove/Install trim - B-Pillar finisher
          DA-RM-08N001-09-004 - Remove/Install duct - Demist
          DA-RM-08N001-09-005 - Remove/Install Headlining base - Door
        Sunvisor
        Door Casing
      Interior Restraints
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Interior / Interior Systems / Upper Trim / DA-RM-08N001-09-002 - Remove/Install trim - Headliner
Preparation work
1.     
Care Point: Remove both sides.
2.     
Care Point: Remove both sides.
3.     
4.     
Care Point: Remove both sides.
5.     
6.     
Care Point: Remove both sides.
Remove trim - Headliner
 
Care Point:
When removing components around the mirror assembly do not allow any parts or tools to strike the mirror.
Care Point:
When removing sunvisors have a second technician support the headliner.
 
1.  
Partially remove the door seals.
 
 
Care Point:
If fitted.
 
2.  
Disconnect camera electrical connector.
 

3.  
Detach headliner rear clips and detach velcro at centre of headliner (1).
 
4.  
Remove headliner from vehicle.
 
Install trim - Headliner
 
Care Point:
Make sure roof harness connectors are correctly positioned.
Care Point:
Inspect and replace any damaged clips.
 
1.  
Install components in reverse order.
 
   
   
   Note