Preparation work
Drain fluid - Transmission
| | | Care Point: | Use a suitable container to catch the excess fluid.
|
| | | 1. | Remove drain plug (1). 50 Nm
| | | | | Care Point: | Allow approximately 2 minutes for oil to drain.
|
| | | 2. | Let the oil drain completely.
| | | 
|
Fill fluid - Transmission
| | | Care Point: | Renew drain plug copper washer.
|
| | | 1. | Close drain plug (1). 50 Nm
| | | 
|
| 2. | Remove the plug (2).
| | | | | Care Point: | Use a clean funnel and pipe.
|
| | | 3. | Fill up to level plug (2) (approximately 3 litres). PTX 75W-90
| | | 4. | Install the plug (2).
| | | | | Care Point: | Make sure the clutches are opened, no gears engaged, no torque.
|
| | | 5. | Run the engine for 2 minute at idle speed.
| | | 6. | Remove the plug (2).
| | | | | Care Point: | Level needs to be topped up within a minute of the stopping engine and removing plug (2).
|
| | | 7. | Top up transmission oil until it reaches the level plug (2).
| | | 8. | Install the plug (2).
| | | | | Care Point: | Check the temperature with MDS.
|
| | | 9. | Run the engine until transmission oil temperature reaches a minimum of 95°C.
| | | 10. | Remove the plug (2).
| | | | | Care Point: | Level needs to be topped up within a minute of reaching 95°C with the engine off and the fill plug removed (2).
|
| | | 11. | Top up transmission oil until it reaches the level plug (2).
| | | 12. | Renew fill plug copper washer.
| | | 13. | Install the plug (2). 50 Nm
| | | 
|