Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
      Suspension Front
      Suspension Rear
      Suspension - Systems
      Suspension - Wheels and Tyres Front
      Suspension - Wheels and Tyres Rear
      Brakes Front
      Brakes Rear
      Brakes - Systems
        Brakes - Systems Service Procedures
        Pedal Box
          DA-RM-04C003-01-001 - Remove/Install pedal - Throttle
          DA-RM-04C003-01-002 - Remove/Install pedal - Brake
          DA-RM-04C003-01-003 - Remove/Install switch - Brake light
          DA-RM-04C003-01-004 - Remove/Install reservoir - Brake fluid
        Brake Boost System
        Brake Pipes
      Brakes - Parking Brake
      Steering
      Fuel Tank
      Fuel System
      Cooling - High Temperature
      Cooling - Low Temperature
      Heating Ventilation & Air Conditioning (HVAC)
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
       Special advice          Tools/Equipment           Fluids, lubricants, adhesive   
Instructions
Chassis / Brakes - Systems / Pedal Box / DA-RM-04C003-01-003 - Remove/Install switch - Brake light
Preparation work
1.     
Remove switch - Brake light
1.  
Disconnect switch brake light electrical connector (1).
 
2.  
Remove inner (2) and outer (3) of switch brake light.
 
Install switch - Brake light
1.  
Install components in reverse order.
 
 
Care Point:
The procedure below must be claimed separately if you make a warranty claim.
 
2.  
Perform a functional check, adjust if required.DA-RM-04C003-00-001 - Adjust switch - Brake light
 
   
   
   Note