Repair instructions
    Body Structures
    Body Panels and Closures
    Body Exterior
    Chassis
      Suspension Front
      Suspension Rear
      Suspension - Systems
      Suspension - Wheels and Tyres Front
      Suspension - Wheels and Tyres Rear
      Brakes Front
        Brakes Service Procedures
        Brake Discs Front
        Brake Calipers Front
          DA-RM-04C001-02-001 - Remove/Install brake caliper - Front
          DA-RM-04C001-02-002 - Remove/Install brake pads - Front
          DA-RM-04C001-02-003 - Inspect Front Brake Pads
        Brake Disc Cooling Front
      Brakes Rear
      Brakes - Systems
      Brakes - Parking Brake
      Steering
      Fuel Tank
      Fuel System
      Cooling - High Temperature
      Cooling - Low Temperature
      Heating Ventilation & Air Conditioning (HVAC)
    Powertrain
    Electrical
    Interior
    Accessories
    PDI/Service/Track/Technical Sheets
    Paint Technical Data Sheets
    Wiring Schematics
  Customer Service
Special advice
Chassis / Brakes Front / Brake Calipers Front / DA-RM-04C001-02-001 - Remove/Install brake caliper - Front
WARNING!
 
Risk of poisoning and injury when handling brake fluid!
Swallowing brake fluid can cause symptoms of poisoning such as headaches, dizziness, stomach pains, vomiting, diarrhoea, cramps and unconsciousness.
A dose of more than 100 cm3 can have fatal consequences.
Contact with brake fluid can cause serious skin damage to unprotected skin.
Wear safety glasses and protective clothing such as rubber gloves.
•
Ensure that brake fluid is only accessible to authorized personnel.
•
Store brake fluid in original containers only.
•
Only store brake fluid in suitable, appropriately marked containers.
•
Never put brake fluid in beverage containers.
 
WARNING!
 
Risk of accident due to lack of braking effect!
When the brakes are used for the first time after any work was performed on the braking system’s hydraulics area, the risk of an accident is increased due to an impaired braking effect.
Press the brake pedal several times to build up pressure in the brake system after finishing work on the braking system’s hydraulics area and before starting the vehicle.
•
Hold the brake pedal in a pressed down position for approximately 30 s once pressure has been built up in the brake system, the pressure in the brake system must not drop during this time.
 
WARNING!
 
Possible fluid spills from vehicle systems during repairs or maintenance.
Risk of thermal incidents, slip hazards, corrosion of electrical components, failure of electrical or mechanical components or unwanted odours.
Always limit fluid spills and fully clean the spilled fluid after repairs or maintenance.
 
   
   
   Note