Preparation work
| 1. | |
| 2. | Care Point: Left side only
|
| 3. | Care Point: Left side only
|
WAL - Reinforcement Procedure
| 1. | For the necessary parts, refer to the table that follows:
Quantity
| Part Name
| Part Number
|
1
| Kevlar/carbon sheet kit
| 14AD017CP
|
| | |
|
| 2. | Make sure that the area shown (1) is clean and dry. Use a solution of soap and water.
| | | 3. | Remove the adhesive backing from the Kevlar/carbon sheet.
| | | 
|
| 4. | Attach the Kevlar/carbon sheet to the WAL (2).
| | | 
|
| 5. | Drill 4 x 8mm holes through the Kevlar/carbon sheet and the wheel arch liner in the positions shown (3).
| | | 
|
| 6. | Install the Scrivets (00RA146) through the inner of the WAL into the Kevlar/carbon sheet (4).
| | | 7. | Install the components in reverse order.
| | | 
|