Preparation work
 WARNING!
| |
Risk of injury from moving parts!
When working on components which can be moved either by hand, by means of electric motors, or hydraulically/pneumatically via linkage, serious injuries can occur to body parts being trapped, crushed or severed.
Monitor hazard area.
| • | Secure area against unauthorised access when parts are in motion.
| | • | Never touch the mechanism of a component while it is being actuated.
| | • | Choose a test cable of sufficient length.
|
| |
WARNING!
| |
Risk of injury from moving parts!
When working on components which can be moved either by hand, by means of electric motors, or hydraulically/pneumatically via linkage, serious injuries can occur to body parts being trapped, crushed or severed.
Monitor hazard area.
| • | Secure area against unauthorised access when parts are in motion.
| | • | Never touch the mechanism of a component while it is being actuated.
| | • | Choose a test cable of sufficient length.
|
| |
Remove brake caliper - Parking
| | | Care Point: | The Electronic Parking Brake (EPB) is inoperative during this sequence.
|
| Care Point: | The EPB calipers must be set in the fully open position before any mechanical work is carried out.
|
| | | 1. | Connect McLaren Diagnostic System (MDS), proceed to Diagnostic Toolbox within Electronic Stability Program (ESP).
| | | 2. | Access Sequences.
| | | 3. | Perform EPB Enter Maintenance Mode.
| | |
|
| | | Care Point: | Make sure electrical connector is clean prior to disconnection.
|
| Care Point: | DO NOT use hand tools to disconnect electrical connector.
|
| | | 4. | Disconnect electrical connector (1).
| | | 5. | | | | 6. | Remove brake caliper - Parking (3).
| | | 
|
Install brake caliper - Parking
| | | Care Point: | Make sure electrical connector is fitted correctly and locked.
|
| | | 1. | Install components in reverse order.
| | | | | Care Point: | The EPB calipers must be set in the fully closed position when any mechanical work is complete.
|
| Care Point: | The EPB will be applied to Make sure it is safe to proceed with this sequence.
|
| | | 2. | Connect McLaren Diagnostic System, proceed to Diagnostic Toolbox within Electronic Stability Program (ESP).
| | | 3. | Access Sequences.
| | | 4. | Perform EPB Exit Maintenance Mode.
| | | 5. | Carry out EPB Assembly Check.
| | | | | Care Point: | Carry over EPB Caliper Usage Reset sequence only if an EPB Caliper has been replaced.
|
| | | 6. | Carry out EPB Caliper Usage Reset sequence.
| | |