Instructions
Chassis / Brakes - Systems / Brake Pipes / DA-RM-04C003-04-002 - Remove/Install brake flexi hose - Rear
Preparation work
1.     
2.     

WARNING!
 
Risk of poisoning and injury when handling brake fluid!
Swallowing brake fluid can cause symptoms of poisoning such as headaches, dizziness, stomach pains, vomiting, diarrhoea, cramps and unconsciousness.
A dose of more than 100 cm3 can have fatal consequences.
Contact with brake fluid can cause serious skin damage to unprotected skin.
Wear safety glasses and protective clothing such as rubber gloves.
Ensure that brake fluid is only accessible to authorized personnel.
Store brake fluid in original containers only.
Only store brake fluid in suitable, appropriately marked containers.
Never put brake fluid in beverage containers.
 

WARNING!
 
Possible fluid spills from vehicle systems during repairs or maintenance.
Risk of thermal incidents, slip hazards, corrosion of electrical components, failure of electrical or mechanical components or unwanted odours.
Always limit fluid spills and fully clean the spilled fluid after repairs or maintenance.
 

Remove brake flexi hose - Rear
 
Care Point:
Use a suitable container to catch any excess fluid.

Care Point:
Close off the caliper with a suitable plug.

 
1.  
Remove banjo bolt (1) with copper washer. (M10) 42 Nm
 
 
Care Point:
Counter hold bolt when removing nut.

 
2.  
Remove nut (2). (M5) 5 Nm
 

3.  
Detach union nut (3).(M10) 14 Nm
 

4.  
Loosen nut (4). (M10) 17 Nm
 
5.  
Remove brake flexi hose - Rear (5).
 


Install brake flexi hose - Rear
 
Care Point:
Make sure union is clean and free from dirt and debris to avoid contamination.

Care Point:
Replace copper washer.

 
1.  
Install components in reverse order.
 
 
Care Point:
The procedure below must be claimed separately if you make a warranty claim.

 
2.   

   
   
   Note